Downloads
Electronic Tap Hammer for Composite Damage Assessment
( 77KB )The percentage of composite materials used on new aircraft continues to rise, creating a greater need for NDI methods that can be used on aircraft and are effective in identifying degradation and damage in composite structures.
HB-1 Certification Test Report
( 461KB )The heat bonding system shall be subjected to an Explosive Atmosphere Test in accordance with MIL-STD-810E, Method 511.3, Procedure I. The test shall be conducted at site ambient altitude and temperature.
Portable Thermocouple Welder Operations Manual
( 461KB )The Weld-X is a portable capacitive discharge wire welding unit that allows thermocouple wires to be directly welded to metal surfaces for temperature sensing. This direct bonding avoids the need for clamps, brackets, straps, welded wells, etc.
HB-1 Operation Manual HB-1 Operation Manual
( 1.01MB )The HB-1 repair tool is used to cure (via heat and vacuum/pressure) the adhesive resins found within materials and metal-to-metal bond repairs. Composite material repairs are usually accomplished under pressure using a vacuum bagging method where a high temperature film is sealed over the patch and a vacuum is applied through the film.
HB-2 Operation Manual HB-2 Operation Manual
( 784KB )The HB2 repair tool is used to cure (via heat and pressure) the adhesive resins found within composite materials and metal-to-metal bond repairs. Composite material repairs are usually accomplished under pressure using a vacuum bagging method where a high temperature film is sealed over the patch and a vacuum is applied through the film
RD-3 Operation Manual RD-3 Operation Manual
( 784KB )The RD3 is designed to be a low cost, simple device requiring minimum training for the detection and quantifying of damage in bonded structures.
